How to Install
Illustration 4.39 Control Card Wiring Path for the D13
VLT AQUA Low Harmonic Drive Operating Instructions
Illustration 4.40 Control Card Wiring Path for the E9
4.6.21 Access to Control Terminals
All terminals to the control cables are located beneath the
LCP (both filter and frequency converter LCP). They are
accessed by opening the door of the unit.
4.6.22 Electrical Installation, Control
To connect the cable to the terminal:
®
MG20T202 - VLT
is a registered Danfoss trademark
Terminals
1.
Strip insulation by about 9-10 mm
2.
1)
Insert a screwdriver
in the square hole.
9 - 10 mm
(0.37 in)
51
4
4