Terminal Locations - Frame Size E9 - Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual

How to Install

4.3.4 Terminal Locations - Frame Size E9

Take the following position of the terminals into consid-
eration when designing the cable access.
4 4
Illustration 4.15 Terminal Locations Mains Cables
FASTENER TORQUE
-R 81
458,1
[18.0]
322,5
[12.7]
,0
[.0]
Illustration 4.16 Terminal Locations Motor Cables
Note that the power cables are heavy and difficult to
bend. Consider the optimum position of the frequency
converter for ensuring easy installation of the cables.
24
VLT AQUA Low Harmonic Drive Operating Instructions
332.5
[13.1]
.0
[.0]
M8 9.6 NM (7 FT-LB)
+R 82
FASTENER TORQUE
FASTENER TORQUE M8 9.6 NM (7 FT-LB)
W/T2 97
19 Nm (14 FT-LB)
U/T1 96
W/T3 98
MG20T202 - VLT
M10 19 N
Each terminal allows use of up to 4 cables with cable lugs
or use of standard box lug. Earth is connected to relevant
termination point in the frequency converter.
®
is a registered Danfoss trademark
Section shown
↓
Section shown
↓