Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual page 7

How to Read these Operating...
1 1
1.1.3 Software Version and Approvals
This manual can be used with all VLT AQUA Low Harmonic Drive frequency converters with software version 1.84.
The software version number can be found in parameter 15-43 on the drive LCP.
NOTE
The VLT AQUA Low Harmonic Drive has two different LCPs,
one for the frequency converter (to the right) and one for
the active filter (to the left). Each LCP controls only the
unit it is connected to and there is no communication
between the two LCPs. There is a start/stop signal between
the two units.
Symbols
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operate equipment at
less than optimal performance.
Approvals
6
VLT AQUA Low Harmonic Drive Operating Instructions
VLT AQUA Low Harmonic Drive
Software version: 1.84
®
MG20T202 - VLT is a registered Danfoss trademark