Filter Specifications - Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual

General Specifications
4) The typical power loss is at nominal load
conditions and expected to be within +/-15%
(tolerence relates to variety in voltage and cable
conditions). Values are based on a typical motor
efficiency (eff2/eff3 border line). Motors with
lower efficiency will also add to the power loss in
the frequency converter and opposite. If the
switching frequency is increased comed to the
default setting, the power losses may rise signifi-

8.2 Filter Specifications

Frame size
Voltage [V]
Current, RMS [A]
Peak Current [A]
RMS overload [%]
Response time [ms]
Settling time - reactive current control [ms]
Settling time - harmonic current control
(filtering) [ms]
Overshoot - reactive current control [%]
Overshoot - harmonic current control [%]
Table 8.1 Power Ranges (LHD with AF)
VLT AQUA Low Harmonic Drive Operating Instructions
D E
380-480 380-480
120 210
340 595
No Overload
<0.5
<40
<20
<20
<10
®
MG20T202 - VLT is a registered Danfoss trademark
cantly.LCP and typical control card power
consumptions are included. Further options and
customer load may add up to 30 W to the losses.
(Though typical only 4 W extra for a fully loaded
control card, or options for slot A or slot B, each).
Although measurements are made with state of
the art equipment, some measurement
inaccuracy must be allowed for (+/-5%).
F
380-480
330 Nominal value
935 Amplitude value of the current
60 s in 10 min
8 8
153