Accessing The Internal Memory Of The 2000 Platform - Viavi MTS 2000 User Manual

Chapter 10 File management
Working with directories and files from the explorer
Note the IP address and the mask of the PC's sub-network.
2 Plug the RJ 45 connector of the 2000 Platform into a hub or Ethernet
switch with a straight-through Ethernet cable (see
page
3 On the 2000 Platform:
In the system set-up menu, under I/O interfaces > Ethernet, select
Config 1 (or 2 / 3 / 4) on the line Mode, then enter the IP address,
the IP mask of the PC and the IP gateway previously noted
or
use Dynamic attribution mode (DHCP). In this case, the address of
the 2000 Platform (10.33.18.235 in the example) is displayed but
cannot be altered.
4 Wait for about ten seconds while the connection is established.
5 On the PC, make sure that the connection is operational by selecting
Start > Execute... and typing ping followed by the address of the
2000 Platform.

Accessing the internal memory of the 2000 Platform

FTP access is obtained through the user account «mts2000» (password:
Viavi).
1 Make the 2000 Platform / PC connection as described
page
2 On the PC, use an FTP client, and access to internal memory via an
internet explorer (I.E, Mozilla Firefox...) or Windows Explorer.
3 In the address bar, type the following address (10.33.18.235,
being the IP address of the 2000 Platform defined when the connec-
tion was configured; see
ftp://mts2000:Viavi@10.33.18.235/disk/
This allows to access to internal memory.
100
95).
98.
User Manual
Figure 48 on page
79000000203 Rev. 005
Figure 42 on
Figure 46 on
99):
(step 1).