Transportation, Storage And Disposal; Transportation; Storage; Disposal - Edwards iXH100 Instruction Manual

6

Transportation, storage and disposal

6.1

Transportation

Do not drain the oil from the pump(s) whether dangerous substances have been pumped or not.
You must fit blanking plates to seal all vacuum inlet and outlet ports (to prevent possible oil
leakage). You must ensure that the system is correctly labelled, if in doubt contact Edwards.
Follow the procedure laid out in
back of this manual.
6.2

Storage

Drain the cooling-water from the system if you will transport or store it in conditions where the cooling-water could
freeze (refer to Section 5.3). If you do not, the cooling-water may freeze in the system and damage the pump(s) and/
or the cooling-water pipelines.
Store the system as follows:
1. Follow the procedure set out in
2. Store the system in clean dry conditions until required.
3. When required for use, prepare and install the system as described in
6.3

Disposal

Dispose of the system and any components safely and in accordance with all local and national
safety and environmental requirements.
This equipment may contain a lithium manganese dioxide battery which, under California law,
requires notification for the presence of perchlorate: Perchlorate Material - special handling may
apply, refer to www.dtsc.ca.gov/hazardouswaste/perchlorate/
Edwards products are supported by a world-wide network of Edwards Service Centres. Each Service Centre offers a
wide range of options including disposal. Refer to
Pump system materials suitable for recycling include cast iron, steel, PTFE, stainless steel, brass, aluminium, zinc
alloy, nickel, mild steel, ABS, polyamide.
Take particular care with the following:
Fluoroelastomers which may have decomposed as the result of being subjected to high temperatures.

Components which have been contaminated with dangerous process substances.

Lithium battery.

© Edwards Limited 2012. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
WARNING
Section 6.2 and then read form HS1 and fill out form HS2, which can be found at the
Section 5.2.
WARNING
Section 7.2
Section 3 of this manual.
for more information.
M561-00-880 Issue C
Page 51