Operation; Input Operation Port Setting - Edwards STP Series Instruction Manual

3

OPERATION

The I/O Remote Interface provides remote control of an Edward's pump. You should
3.1

Input operation port setting

The STP pump needs to set the hardware which operates the STP pump before the operation.
The STP pump is equipped with the parallel port (X4 REMOTE connector) and the serial port COM2
(X2 COM2 connector) as standard operating hardware. The STP-Link (optional accessory) or the
display unit iDT-002 (optional accessory) can also operate the STP pump via the serial port (X5 STP-
LINK connector).
The default setting of the Remote Operation Mode is "I/O Remote" (parallel port). It can be set via
serial communication or the STP-Link (optional accessory).
When setting the input port to the parallel port, refer to Section 3.5, "Parallel port input/output signal".
When setting it to the serial port, refer to Section 5, "SERIAL COMMUNICATION PROTOCOL" in the
STP pump Instruction Manual.
The method of operation with the parallel port (X4 REMOTE connector) is shown below. Read
Section 3.5, "Parallel port input/output signal", and follow it.
When operating the STP pump via serial communication, refer to Section 5, "SERIAL
COMMUNICATION PROTOCOL" in the STP pump Instruction Manual.
When operating the STP pump via the STP-Link (optional accessory) or the display unit iDT-002
(optional accessory), refer to each Instruction Manual.
I/O Remote Interface
refer to the safety information in the pump instruction manual.
This unit should not be relied upon for safety related functions.
WARNING
3
MT-91E-C01-0
Page 7