Table of Contents
Advertisement
Description
Mains connection
Refer to installation section for wiring diagram
PDT Interface (front)
System Interface (rear)
Ethernet interface
EMS interface
External emergency stop switch
Pin 1 - supply, Pin 2 - return
Note: If there is no external connection a link
plug must be fitted to operate the pump.
Internal emergency stop switch
Pin 3 - common, Pin 4 - normally open
Comms 24 V supply
Pin 5 - supply, Pin 6 - 0 V supply common
Chassis
Table 9 - Electrical connections
Mating Connector description / external supply rating
Refer to
Table 7
for the mains connector fitted to each variant.
Connector is either:
Harting Han® K 4/4-F finger safe
09 38 008 2703, 6-16 mm
(VDE 0295 class 5, refer to
Table
Harting Han® Axial Screw module 100A (2 off required), 09 14 002 2753 10-25 mm
or 09 14 002 2751, 16-35 mm
(VDE 0295 class 5, refer to
Harting Han® Axial Screw module 200A (3 off required), part number of mating
2
half suitable for 25 - 40 mm
wire is 09 14 001 2763 or 09 14 001 2762 for
2
40 - 70 mm
wire. Use fine stranded wire (VDE 0295 class 5, refer to
XLR type 5-way plug
XLR type 5-way plug
Standard RJ45 type or Neutrik® EtherCon® RJ45
XLR type 6-way plug
30 V a.c. 1 A, 60 V d.c. 0.55 A
2
fine stranded wire
10), 8.9mm max insulation diameter
Or
2
fine stranded wire
Table
10)
Or
Table
Internal supply rating
2
10)
24 V d.c. 0.2 A
*
24 V d.c. 0.75 A
(IEEE802.3i
10 Base T Ethernet)
24 V d.c. 100 mA
*
24 V d.c. 0.75 A
Hide quick links:
Advertisement
Table of Contents
