2-10
Connecting the interlock jumper
1.
Insert a screwdriver into A to open B.
2.
Insert the interlock jumper into B. Confirm that the cable shield is not
caught in the jumper.
3.
By lightly pulling on the jumper, confirm that it is connected securely.
4.
Take the same steps for the positive (+) and negative (-), then short-cir-
cuit both sides.
Shank diameter: ø3; tip width: 2.6 mm
Fig.2-6
Connecting the jumper
A
B
TOS9213S/ TOS9213AS