Kikusui TOS9213S Operation Manual page 23

■ High-voltage test probe HP01A-TOS/HP02A-TOS
This test probe is connected to Kikusui's withstanding voltage tester to output a test
voltage. It is designed to prevent the unintended output of a test voltage.
To output a test voltage, hold the slide lever on the test-probe grip and pull the trig-
ger with one hand, then press the switch on top of the probe using the other hand.
When you release either hand, the STOP signal is output and the test voltage is cut
off.
WARNING
• This probe is designed for a maximum working voltage of 4 kVAC/5 kVDC.
It is dangerous to apply a voltage exceeding this level. Be sure to use this
probe at a test voltage below the maximum working voltage.
• Do not connect this probe to the DUT when a test voltage is being output
from the probe. In addition, do not cut off the connection to the DUT when
a test voltage is being output from the probe.
If the connection between the probe and the DUT is cut off while a high
voltage is being output from the probe, the DUT may be damaged. In addi-
tion, the DUT remains charged, making it extremely dangerous.
Therefore, connect the probe to a DUT before staring a test, be sure to
confirm that the LED on the probe is off before ending a test, and then dis-
connect the DUT from the probe.
CAUTION
• To conduct a test under the UL standard using this probe, turn on the FAIL
MODE function on the tester. When this function is on, the tester performs
the next action to allow the FAIL status to be checked.
When the test ends in the FAIL status, the status is not cancelled even
when you release your hand from the probe. To cancel the FAIL status,
press the STOP switch on the tester. For settings, see "FAIL MODE" in "5.8
System Settings".
TOS9213S/ TOS9213AS
Maximum working voltage
4 kVAC (rms) 50 Hz/60 Hz
5 kVDC
Cable length
HP01A-TOS: Approximately 1.8 m
HP02A-TOS: Approximately 3.5 m
1-9