Table of Contents
Advertisement
Setting the test conditions (Memory No.) and interval time
NOTE
5-54
• If a test condition under the preset memory number is set to TIMER OFF, a pro-
gram test ends once the STOP switch is pressed, preventing the next test from
being performed.
For each step, set the memory number of the test conditions to be used and the inter-
val between steps. The program executes the test in order of step number.
When the cursor is positioned at the step number, the screen can be scrolled using
the rotary knob. The
location of the cursor.
Upon completion of each step, "END" or "RET" is displayed.
1.
To move the cursor to the step number, press the SHIFT + F1 keys.
2.
Move the cursor to the step below the step to be inserted. To add a step
to the previous step, move the cursor to END or RET.
3.
Press the F1 key (INS). A step (DCW00-0.2s) will be inserted at the
cursor.
4.
Using the
key, move the cursor to DCW to the right of the step num-
ber.
5.
Using the rotary knob, set the target test (DCW, IR, EC).
To control the earth continuity tester TOS6200, select EC. See "Chapter 8 Con-
trolling the TOS6200".
6.
Using the
key, move the cursor to the memory number.
7.
Using the rotary knob, set a memory number.
8.
Using the
key, move the cursor to the interval time to the right of the
memory number.
9.
Using the rotary knob, set an interval time (from 0.2 s to 9.9 s, HOLD).
If the interval time is set to HOLD, the next step starts when the START switch
is pressed with the specified step in the HOLD status.
To delete a step, move the cursor to the corresponding step number and press the F2
key (DEL).
To change the interval time or the memory number of a step, move the cursor to the
target and make changes using the rotary knob.
keys can be used to perform scrolling, regardless of the
TOS9213S/ TOS9213AS
Advertisement
Table of Contents
