Kikusui TOS9213S Operation Manual page 213

Tos9200 dc withstanding voltage and insulation resistance tester
Table of Contents

Advertisement

Input specifications
High-level input voltage
Low-level input voltage
Low-level input current
SIG-
Input period
NAL
Output specifications
I/O
Output method
Output withstanding voltage
Output saturation voltage
Maximum output current
STATUS OUT
+ terminal (red)
- terminal (black)
INTERLOCK input
+ terminal (yellow)
- terminal (yellow)
SCANNER
RS-232C
Communication speed
TOS6200 interface
(only in AUTO mode)
GPIB
TOS9213S/ TOS9213AS
11 V to 15 V
Low active control of all input signals
The input terminal is pulled up by the resistance
0 V to 4 V
to +12 V.
Maximum of –5 mA
Opening the input terminal is equivalent to
inputting a high-level voltage.
Minimum of 5 ms
Open collector output (4.5 V to 30 V DC)
30 V DC
Approximately 1.1 V (25 °C)
400 mA (TOTAL)
Output terminal for the warning light
Outputs +24 V during the preset period with a maximum output current of 100 mA
+24 V circuit common line
Cuts off output when the + and – terminals are opened, and enters the
PROTECTION status to disable testing
Interlock input
Open: When the current between terminals is
+ terminal
0.5 mA or less
Interlock input
Short-circuited: When the current between ter-
– terminal
minals is 1 mA or more
8-pin MINI DIN connector on rear panel
Interface terminal for optional high-voltage scanner TOS9220/9221
9-pin D-SUB connector on rear panel (conforming to EIA-232-D)
Remote control possible for all functions other than POWER switch, KEY-
LOCK, and AUTO
9600 bps/19200 bps/38400 bps
START/STOP control, test-condition settings
Reads TOS6200 measurements and measurement results
Conforms to IEEE Std.488-1978
Remote control possible for all functions other than POWER switch, KEY-
LOCK, and AUTO
Function
Subset
Source handshaking
SH1
Acceptor handshaking
AH1
Talker
T6
Expansion talker
TE0
Listener
L4
Expansion listener
LE0
Service request
SR1
Remote local
RL1
Parallel port
PP0
Device clear
DC1
Device trigger
DT0
Controller
C0
Electrical interface
E1
Description
All functions provided
All functions provided
All functions provided except for the talk-
only function
No function
All functions provided except for the lis-
ten-only function
No function
All functions provided
All functions provided
No function
All functions provided
No function
No function
Open collector
10-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tos9213as

Table of Contents