CLR
DSE
DSR
ERR
7-12
Resets all registers exclusive of enable register and sets the STOP flag.
The same procedure is performed as when the GPIB bus line message DCL or SDC
has been received.
Also used to perform the same processing as is performed by a DCL message from
the RS-232C.
Message
Setting: CLR
Sets or resets each bit of the device-status enable register, or inquires about the con-
tents of the register.
For details on the device-status enable register, see "7.5 Registers".
Message
Setting: DSE_<value>
DSE?
Query:
Program data
Data format: Hexadecimal or decimal
Set value:
00H to FFH (0 to 255)
Resolution:
1H (1)
(Example) To set the device-status enable register to 01H,
DSE #H01
Response
To DSE?, the contents of the device-status enable register are returned.
(Example) When Bit 5 of the device-status enable register is set, 32 is returned.
Used to inquires about the contents of the device status register.
For details on the device status register, see "7.5 Registers".
Message
DSR?
Query:
Response
To DSR?, the contents of the device status register are returned.
(Example) When Bit 5 of the device-status enable register is set, 32 is returned.
The error register is reset when read by the ERR? Message.
For details on the error register, see "7.5 Registers".
Message
ERR?
Query:
TOS9213S/ TOS9213AS