Separating Engine From Clutch Housing - Kubota M108S Workshop Manual

M108S, WSM

(2) Separating Engine from Clutch Housing

Front Axle Support as a Unit
1. Check the front axle and clutch housing case are securely
mounted on the disassembling stands.
2. Install the front axle rocking restrictor (1) (refer to "8. SPECIAL
TOOLS" at "G. GENERAL" section) to the front axle bracket.
3. Separate the front axle support as a unit after removing the front
axle support mounting screws.
(When reassembling)
Front axle support
Tightening torque mounting screw
(M14, UBS)
(1) Front Axle Rocking Restrictor
Wire Harness and Hose
1. Remove the ground cable (1) and wire harness (2).
2. Disconnect the EGR connector (3) and supply pump connectors
(4), (5).
3. Disconnect the throttle sensor connector (6).
4. Remove the throttle cable (7).
5. Disconnect the heater hoses (8).
(When reassembling)
• Be sure to connect the heater hoses to original position.
(1) Ground Cable
(2) Wire Harness
(3) EGR Connector
(4) Supply Pump Connector
Joint Shaft, Hose, Brake Oil Tank and Connector
1. Disconnect the power steering delivery hose (3).
2. Remove the joint shaft (2) and power steering controller (4).
3. Disconnect the connectors (5), (6).
4. Remove the breather hose (7).
5. Disconnect the connector (8) and remove the brake tank (1).
(When reassembling)
Delivery hose retaining nut
Tightening torque
Power steering controller
mounting screw
(1) Brake Oil Tank
(2) Joint Shaft
(3) Delivery Hose
(4) Steering Controller
1-S23
ENGINE
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
W1033876
(5) Supply Pump Connector
(6) Throttle Sensor Connector
(7) Throttle Cable
(8) Heater Hose
W1013854
22 to 27 N·m
2.2 to 2.8 kgf·m
16 to 20 lbf·ft
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(5) Connector
(6) Connector
(7) Breather Hose
(8) Connector
W1014144
KiSC issued 06, 2007 A