Installing The Deskside Cover; Deskside Assembly Kit - IBM TS2900 Setup, Operator, And Service Manual

v Allow the packaged product to acclimate for 24 hours.
|
external or internal to the product) after 24 hours, acclimate the system without the shipping bag for
|
| an additional 12 - 24 hours or until no visible condensation remains.
v Acclimate the product away from perforated tiles or other direct sources of forced air convection to
|
minimize excessive condensation on or within the equipment.
|
1
Unless otherwise stated by product-specific installation instructions.
|
| Note: Condensation is a normal occurrence, especially when you ship equipment in cold-weather
®
climates. All IBM products are tested and verified to withstand condensation that is produced under
|
these circumstances. When sufficient time is provided to allow the hardware to gradually acclimate to the
|
| indoor environment, there should be no issues with long-term reliability of the product.

Installing the Deskside Cover

A deskside cover and six desktop feet must be installed on the library chassis before the library can be
used as a desktop unit. If you intend to install the library in a rack, skip this step and proceed to
"Installing in a rack" on page 26.
Table 14 lists the parts in the deskside assembly kit. A Phillips head screwdriver (preferably with a
magnetic head) is needed to assemble the deskside kit.
Table 14. Deskside Assembly Kit
Number Part Number
1
45E3240
2
45E3798
3
45E3799
4
45E3749
Quantity Description
6 1U desktop foot
1 Deskside cover
Bracket, 1U library right
1
rail
Screw, cross-recessed
binding head, M4x4 (for
2
securing the rear of the
cover to the library)
1
If there are visible signs of condensation (either
Installation and configuration
Part
23