IBM TS2900 Setup, Operator, And Service Manual page 160

2. If power is not working:
a. Plug the power cord into another electrical outlet.
b. Plug another device into the outlet to test.
c. If the outlet tests OK, try another power cord.
3. If you verified that the electrical outlet and power cord works properly, but the power supply is still
failing, replace the library (see "Replacing the library" on page 153).
4. If the power supply seems to be delivering power to the library; but air does not flow from the
power-supply cooling fan grill on the rear of the library, replace the library (see "Replacing the
library" on page 153).
Isolating drive problems
1. Ensure that the drive firmware is at the latest level (visit http://www.ibm.com/storage/).
2. Cycle library power.
3. If the drive is experiencing permanent or temporary errors or if the Clean LED is lit on the front
panel of the library, clean the drive.
4. Run Library Verify.
a. If the test fails, replace the library.
b. If the test passes, run SAS Wrap Test.
1) If the test passes, resume normal library operations.
2) If the test fails, replace the library.
5. With the host interface test tool, ITDT, run the Scan functions to verify that the host application
interface can detect the drive and the library. To further test the interface communication path, run the
Test Device function, if available, after the drive is selected. This function writes and reads data across
the interface, also sending a command to the drive to run the internal performance read/write test.
6. If the host tool, ITDT, cannot detect the drive or library, look for problems with the host interface
cabling, the HBA, the device driver, or the backup application software.
Isolating Web User Interface problems
1. Verify that you entered the account name and password correctly. The account name and password
are case-sensitive.
2. Verify that other library users are not entering commands from the Web User Interface or Operator
Panel at the same time you are issuing commands.
3. Ensure that library firmware is at the latest level (visit http://www.ibm.com/storage/).
4. Ensure that the Ethernet cable is securely plugged in the rear of the library at the Ethernet port.
5. Ensure that the correct IP, netmask, and gateway addresses are keyed into the network parameters.
6. Ensure that the correct IP address is being used on the web browser.
7. If the Ethernet connection is a direct connection between the PC and the library, a special "crossover"
Ethernet cable is required.
Note: On newer PCs, either straight through or crossover Ethernet cables might be used since the
crossover requirement is provided internally.
8. Check the Ethernet cable carefully (or try another cable) and, if the cable is connected to a network
hub or switch, try a different port.
9. If the Web User Interface is still malfunctioning, refer to "Contacting IBM technical support" on page
139.
134
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572