Table of Contents
Advertisement
Completing the installation
To complete the installation, you must reinstall the bezel, reinstall the side cover,
connect all the cables and, for certain options, run the Configuration/Setup Utility
program. Follow the instructions in this section.
Installing the bezel
To replace the bezel, complete the following steps:
1. Insert the two alignment tabs at the top of the bezel into the bezel retention
2. Push the bottom of the bezel toward the server until the bezel snaps into place.
Installing the side cover
Note: You might find it easier to lay the server on its side to replace the side cover.
To replace the side cover, complete the following steps:
1. Before installing the cover, check that all cables, adapters, and other
2. Align the cover over the server (with the rear of the cover slightly hanging off
slots at the top of the chassis.
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
the rear of the server) and slide the cover toward the front of the server until it
is completely closed.
Chapter 2. Installing options
25
Advertisement
Table of Contents
