IBM TS2900 Setup, Operator, And Service Manual page 232

Table 37. TapeAlert flags supported by the Ultrium tape drive (continued)
Flag Number
56 Unload failure
59 WORM Media
integrity check
failed
60 WORM Media
overwrite attempted
206
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
Flag Name
Set when a drive hardware error
prevents the tape cartridge from
being unloaded from the tape
drive, or when the tape cartridge is
stuck in the drive.
Set when the drive determines that
the data on the tape is suspect from
a WORM point of view.
Set when the drive rejects a write
operation because the rules for
allowing WORM writes are not
met. Data is appended to WORM
media only. Overwrites to WORM
media are not allowed.
Description
1. Unload the cartridge from the
2. Try a power cycle of the entire
3. Try to unload the cartridge
4. If the cartridge still does not
1. Copy the data to another
2. Discard the old WORM tape.
Append the information about a
WORM tape cartridge or write the
data to a non-WORM cartridge.
Action Required
drive with the Operator Panel
or the Web User Interface.
library. This procedure causes
the drive to reset and attempt
to rewind and unload when
power is restored. If the
cartridge unloads, remove it
from the library and inspect it.
If damaged, discard it.
from the drive again with the
Operator Panel or the Web User
Interface.
unload from the drive, see
"Contacting IBM technical
support" on page 139.
WORM tape cartridge.