IBM TS2900 Setup, Operator, And Service Manual page 221

Table 32. Library error codes (continued)
Code (H) Description
An error detected during bar code
reader firmware check. Suspect
00DD
the bar code reader cable
connection.
Write operation not finished
00E0 within 1 ms when writing data to
flash memory.
Clear operation not finished
00E1 within 10 seconds when clearing a
sector in flash memory.
Error detected in tape library
00E2 configuration stored in flash
memory.
Checksum error detected in flash
00E3
memory.
Sensor error #1.
Accessor encoder sensor B error
00F0
detected during blink check.
Suspect the accessor encoder
sensor B.
Panel Indication
1. Initiate an inventory. See "Conducting a
library inventory" on page 66 (Operator
Panel) or "Conducting a library inventory"
on page 81 (Web User Interface).
2. Cycle the power supply and try again.
CHK 00DD
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see "Contacting
IBM technical support" on page 139.
Cycle the power supply and try again.
CHK 00E0
v If the problem is corrected, run Library Verify
before normal library operations resume.
v If the problem persists, see "Contacting IBM
CHK 00E1
technical support" on page 139.
CHK 00E2
CHK 00E3
CHK 00F0
Action Required
Appendix B. Error codes
195