Configuring Network Settings - IBM TS2900 Setup, Operator, And Service Manual

Configuring network settings

Figure 71. Network settings
Select Configuration > Configure Network Settings to set the network settings for the library.
Note: The Internet Protocol (IPv4, IPv6, or dual IPv4/IPv6) selection is used for the TS2900 Tape
Autoloader IP address, subnet mask, gateway address, time server address, mail server address, SNMP
trap address, and EKM server addresses.
Configure the network with the following settings:
v Link Speed - Ethernet duplex mode (Auto, 10Base-T Full, 10Base-T Half, 100Base-TX Full, 100Base-TX
Half).
v DHCP - (Dynamic Host Configuration Protocol) Enable DHCP to have the library server or router
negotiate the connection with the library.
– IPv4 - Select to enable DHCP with the IPv4 protocol.
– IPv6 - Select to enable DHCP with the IPv6 protocol
v IP Address - If DHCP is disabled, set the IP address of the library manually.
– IPv4 - Select to enter the library IP address with the IPv4 protocol.
Configuration
Configure Network Settings
Configure Link Speed
Set Auto Negotiation
Set 10 Base-T Full
Set 10 Base-T Half
Set 100 Base-T Full
Set 100 Base-T Half
Configure DHCP
Configure DHCP IPv4
Enable DHCP IPv4
Disable DHCP IPv4
Configure DHCP Ipv6
Enable DHCP IPv6
Disable DHCP Ipv6
Change IP Address
Set IP Address Ipv4
Set IP Address Ipv6
Change Subnet Mask
Set Subnet Mask
Set Prefix Length
Change Gateway
Set Gateway Address Ipv4
Set Gateway Address Ipv6
Input IP Address
Input IP Address x 4
Input Subnet Mask
Input Prefix
Input Gateway
Input Gateway x 4
71
Operations