IBM TS2900 Setup, Operator, And Service Manual page 20

CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures might exceed
v Do not install a unit in a rack where the air flow is compromised. Ensure that air flow is
v Consideration must be given to the connection of the equipment to the supply circuit so
v (For sliding drawers) Do not pull out or install any drawer or feature if the rack stabilizer
v (For fixed drawers) This drawer is a fixed drawer and must not be moved for servicing
(R001)
xx
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
the manufacturer's recommended ambient temperature for all your rack-mounted devices.
not blocked or reduced on any side, front, or back of a unit that is used for air flow
through the unit.
that overloading of the circuits does not compromise the supply wiring or overcurrent
protection. To provide the correct power connection to a rack, refer to the rating labels on
the equipment in the rack to determine the total power requirement of the supply circuit.
brackets are not attached to the rack. Do not pull out more than 1 drawer at a time. The
rack might become unstable if you pull out more than one drawer at a time.
unless specified by the manufacturer. Attempting to move the drawer partially or out of
the rack might cause the rack to become unstable or cause the drawer to fall out of the
rack.