Configuring The Library; Default Library Configuration Settings - IBM TS2900 Setup, Operator, And Service Manual

Configuring the library

The library can be configured with the Web User Interface or the Operator Panel. The preferred method
for configuring your library is by using the Web User Interface. See "Configuring your library with the
Operator Panel" on page 54 and "Configuring your library with the Web User Interface" on page 37.
For complete detailed information about all of the functions available on the library with the Operator
Panel and the Web User Interface, see "Operations" on page 61.
The default library configuration settings are listed in Table 16.
Table 16. Default library configuration settings
Configuration Item
Ethernet link speed
SSL security
IPv4 settings
DHCP (Dynamic Host Configuration Protocol)
Static IP address
IPv4 address
Subnet mask
Gateway
IPv6 settings
DHCP (Dynamic Host Configuration Protocol)
Stateless auto-configuration
Static IP address
IPv6 address
Prefix length
Gateway
DNS setting
DNS IP address
Library name
Auto Cleaning
Bar code label length
Library mode
Loop
Auto Load
Active slots
Encryption method
Encryption policy
SSL security
Primary EKM server address
36
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
NETWORK
PHYSICAL
LOGICAL
ENCRYPTION (S4H and LATER ONLY)
Default Setting
Auto
Disabled
Enabled
Enabled
Disabled
0.0.0.0
255.255.255.0
0.0.0.0
Disabled
Enabled
Enabled
Disabled
0:0:0:0:0:0:0:0
64
0:0:0:0:0:0:0:0
Disabled
0.0.0.0
(Blank)
Disabled
8 characters
Random
Enabled
Enabled
9 + 0
None
Encrypt All
Disabled
0.0.0.0