IBM TS2900 Setup, Operator, And Service Manual page 75

v Location - Physical location of the system.
v Contact - Contact person's name.
v SNMPv3 engine ID - A read-only attribute that identifies the SNMPv3 engine.
| 4. Enter the settings of the SNMP monitoring stations to be notified when an event takes place by
clicking the modify buttons in the Trap List box.
|
|
|
|
Figure 42. SNMP trap settings
|
v Validity - Select the check box to enable and clear the check box to disable.
|
v Address - IPv4 and IPv6 addresses are supported. Host names can be entered instead of numerical
IP addresses if the DNS server is specified.
v Version - Trap version v1, v2c, or v3. For v2c and v3, the Inform check box determines if an SNMP
INFORM request is sent instead of a trap event.
v Community (v1 or v2c) - SNMP community name.
v User name (v3 only) - SNMPv3 unique user name.
v Authentication (v3 only) - Authentication algorithm: disable, MD5, or SHA.
v Authentication Password - When an Authentication algorithm is enabled, an Authentication
|
Password is required. (see "Configuring Password Rules Settings" on page 52).
|
| v Confirm - Re-enter the Authentication Password to confirm it.
| v Privacy (v3 only) - Privacy service encryption and decryption algorithm: disable, DES, or AES.
When an algorithm is specified, a privacy password is required.
|
v Privacy password - enter a password (see "Configuring Password Rules Settings" on page 52).
|
v Confirm - Re-enter the Privacy password to confirm it.
|
| 5. Click Submit to save the SNMP Trap settings. Modify each trap's settings by repeating the previous
step.
|
6. Enter the SNMPv3 users who are allowed to access the tape library by clicking the modify buttons in
|
| the SNMPv3 User List box.
Installation and configuration
49