Cartridge Compatibility; Capacity Scaling; Lto Type M Cartridge (M8); Nominal Cartridge Life: Load/Unload Cycles - IBM TS2900 Setup, Operator, And Service Manual

Table 18. Nominal cartridge life: Load/unload cycles
Type
Ultrium 8
Ultrium M8
Ultrium 7
Ultrium 6
Ultrium 5
Ultrium 4
Ultrium 3
Ultrium 2
Ultrium 1

Cartridge compatibility

For information on Ultrium data cartridge compatibility with Ultrium tape drives, see Table 6 on page 9.

Capacity scaling

To control the capacity of the cartridge (for example, to obtain a faster seek time) issue the SCSI
command SET CAPACITY. For information about this command, refer to the IBM Ultrium Tape Drive SCSI
Reference.

LTO type M cartridge (M8)

The LTO Program introduced a new capability with LTO8 tape drives: the ability to write 9 TB (native)
on a brand new LTO Ultrium 7 cartridge instead of 6 TB (native) as specified by the LTO7 format. Such a
cartridge is called an LTO7 initialized LTO Type M cartridge. These LTO Type M cartridges are
identifiable by using an automation bar code label that ends with the last 2 characters "M8".
Table 19. LTO7 and LTO8 Cartridge Types
Cartridge/Density
type Bar code label
L8 xxxxxxL8
M8 xxxxxxM8
L7 xxxxxxL7
From now on, these cartridges are referred to as L8, M8, and L7.
Only new, unused LTO Ultrium 7 cartridges can be initialized as M8 cartridges. When a cartridge is
initialized as M8, it cannot be changed back to L7. Initialized M8 cartridges can be written and read only
in an LTO8 tape drive. LTO7 tape drives cannot read initialized M8 cartridges.
M8 cartridges can be purchased as either pre-initialized (also referred to as "labeled and initialized") M8
data cartridges or uninitialized M8 data cartridges (M8 WORM cartridges are not supported). For either
option, the bar code label is included. However, the uninitialized M8 data cartridge must first be
initialized in tape libraries that support the automatic initialization of uninitialized M8 cartridges while
under the control of ISV applications that recognize the "M8" bar code label.
A tape cartridge is initialized when it is first loaded into a compatible tape drive and data is written by
the ISV application at the beginning of tape (sometimes referred to as "labeling a tape" or "writing from
BOT"). The tape drive then establishes the density of the media.
Load/Unload Cycles
20,000 (20k)
20,000 (20k)
20,000 (20k)
20,000 (20k)
20,000 (20k)
20,000 (20k)
20,000 (20k)
10,000 (10k)
5000 (5k)
Cartridge
Packaging/Silkscreen
labeling Native capacity
LTO Ultrium 8 12 TB
LTO Ultrium 7 9 TB
LTO Ultrium 7 6 TB
Tape Drive
compatibility
LTO8
LTO8
LTO7, LTO8
109
Media