Installing The Cover - IBM Storwize V7000 Unified Series Problem Determination Manual

2. If you are planning to view the error LEDs that are on the system board and
3. If you are planning to install or remove a microprocessor, memory module, PCI
4. Press down on the left and right side latches and pull the file module out of
5. Push the cover-release latch back 1 , then lift it up 2 .
6. Slide the cover back 3 , then lift the cover off the file module and set it aside.
7. If you are instructed to return the cover, follow all packaging instructions, and

Installing the cover

The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 51.
To install the cover, complete the following steps.
1. To help you work safely with Storwize V7000 Unified file modules, read the
2. Make sure that all internal cables are correctly routed.
3. Place the cover-release latch in the open (up) position.
84
Storwize V7000 Unified: Problem Determination Guide Version
components, leave the file module connected to power and go directly to step
4.
adapter, battery, or other non-hot-swap optional device, turn off the file module
and all attached devices and disconnect all external cables and power cords.
the rack enclosure until both slide rails lock.
Note: You can reach the cables on the back of the file module when the file
module is in the locked position.
Attention: For proper cooling and airflow, replace the cover before turning on
the file module. Operating the file module for extended periods of time (over
30 minutes) with the cover removed might damage file modulefile module
components.
use any packaging materials for shipping that are supplied to you.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 54.