IBM TS2900 Setup, Operator, And Service Manual page 172

4. Attach the deskside cover with the 2 large pan-head screws 4 on the rear of the library
(Figure 138).
Figure 138. Attaching the cover to the library chassis (rear screws)
5. Place the library in the wanted desktop location.
Important: Do not place the library on its side. Do not stack objects on top of the library.
6. Remove the accessor locking screw 1 .
Figure 139. Removing the accessor locking screw
7. On the rear panel of the library:
a. Connect the SAS host interface cable.
b. Connect the Ethernet cable.
c. Connect the power cable from the library power supply. Route all cables through the
hook-and-loop fastener strap.
d. Power ON the library by toggling the power supply switch to the ON (|) position.
8. Insert the cartridge magazine if previously removed.
9. Restore the library configuration. See "Saving and restoring configuration settings" on page 99.
10. From the Operator Panel, select Run Library Verify, and press Enter to run library diagnostic
procedures. Follow the on-screen instructions. If an error occurs, see "Troubleshooting" on page 129.
11. Take the library online.
Important: Do not stack objects on top of the library.
For detailed instructions, see "Installation and configuration" on page 21.
146
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
1
4