Configuring Network Settings; Network Settings Screen - IBM TS2900 Setup, Operator, And Service Manual

Configuring network settings

|
|
| Figure 95. Network settings screen
|
Use Configure Library > Network to set the network settings for the library.
Note: The Internet Protocol (IPv4, IPv6, or dual IPv4/IPv6) selection is used for the TS2900 Tape
Autoloader IP address, subnet mask, gateway address, time server address, mail server address, SNMP
trap address, and EKM server addresses.
Configure the network with the following settings:
v Ethernet - Select link speed duplex mode (Auto, 10Base-T Full, 10Base-T Half, 100Base-TX Full,
|
100Base-TX Half).
v Security - Select Enable SSL for Web to provide secure communications between the web browser and
the tape library.
v TCP/IP settings - IPv4, IPv6, and dual stack IPv4/IPv6 are supported. To enable the dual IPv4/IPv6
protocol, select both Use IPv4 and Use IPv6 and enter parameters for both.
v IPv4 Settings - Select Use IPv4 to enable the IPv4 Internet Protocol. Select the corresponding option to
obtain an IP address automatically (DHCP) or use static IP address settings. When with DHCP, use the
88
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572