Installing Or Replacing The Top Cover: 2077-92F - IBM Storwize V5000 Gen2 Quick Installation Manual

6. Install the outer connector of the lower CMA assembly (
rail 10 , as shown in Figure 55 on page 57.
7. Attach the support rail connector on the lower CMA assembly (
support rail ( 12
Ensure that the lower CMA assembly is securely attached to the hooks on the end of the support rails.
8. Route the cables and power cords on the CMA. If needed, secure them with cable ties or hook-and-
loop fasteners.
Notes:
• Use the cable straps that are provided on the rear of the system to retain the cables and prevent
them from sagging.
• Allow slack in all of the cables to avoid tension in the cables as the CMA moves.
9. Reconnect the power cords and other cables, as needed.

Installing or replacing the top cover: 2077-92F

You can replace the top cover on a 2077-92F expansion enclosure during the installation process or after
you complete a service task.
Before you begin
Important: You can install the cover while the expansion enclosure is powered on. To maintain operating
temperature, replace the cover within 15 minutes of completing other service tasks. When the cover is
removed, the reduction in airflow through the enclosure might cause the enclosure or its components to
shut down to protect from overheating.
About this task
To install or replace the top cover on the 2077-92F expansion enclosure, complete the following steps.
Procedure
1. Carefully lower the cover and ensure that it is aligned correctly with the back of the enclosure, as
shown in Figure 56 on page 58.
Figure 56. Aligning the 2077-92F top cover
2. Push the cover release lever to the side (
3. Slide the cover towards the back of the enclosure (
page 59.
58 Storwize V5000 Gen2: Quick Installation Guide
), as shown in Figure 55 on page 57.
9 ) to the outer member of the right support
11
2 ) as shown in Figure 57 on page 59.
3 ) back until it stops, as shown in Figure 57 on
) to the connector on the left