IBM TS2900 Setup, Operator, And Service Manual page 220

Table 32. Library error codes (continued)
Code (H) Description
accessor operation disabled
because a cartridge magazine was
00C0
removed. Suspect the magazine
set sensor.
Centering calibration error #1.
During centering calibration,
00C8
centering sensor OFF condition
could not be detected. Suspect the
centering sensor or P motor.
Centering calibration error #2.
During centering calibration,
centering sensor ON condition
00C9
could not be detected. Suspect the
centering sensor, X motor, or P
motor.
Checksum error detected during
00D0
firmware update.
Firmware ID error detected
00D1
during firmware update.
Boot information error detected
00D2
during firmware update.
Bar code reader is not in
maintenance mode during bar
code reader firmware update
00D3
(operation interrupted). Suspect
the bar code reader cable
connection.
Magazine failed to unlock.
00D9 Suspect the magazine or
magazine sensor.
I/O Station failed to unlock.
00DA Suspect the magazine or
magazine sensor.
194
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
Panel Indication
1. Confirm that the magazine is closed.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
CHK 00C0
Verify before normal library operations
resume.
v If the problem persists, see "Contacting
IBM technical support" on page 139.
Cycle the power supply and try again.
v If the problem is corrected, run Library Verify
before normal library operations resume.
CHK 00C8
v If the problem persists, see "Contacting IBM
technical support" on page 139.
CHK 00C9
1. Confirm the firmware file version.
CHK 00D0
2. Reinstall the firmware file.
3. Cycle the power supply and try again.
v If the problem is corrected, run Library
CHK 00D1
Verify before normal library operations
resume.
v If the problem persists, see "Contacting
CHK 00D2
IBM technical support" on page 139.
1. Initiate an inventory. See "Conducting a
library inventory" on page 66 (Operator
Panel) or "Conducting a library inventory"
on page 81 (Web User Interface).
2. Cycle the power supply and try again.
CHK 00D3
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see "Contacting
IBM technical support" on page 139.
1. Cycle the power supply and try again.
2. Manually unlock the magazine, remove the
CHK 00D9
magazine from the library, and inspect it for
damage.
v If not damaged, return it to the library and
run Library Verify before normal library
CHK 00DA
operations resume.
v If damaged, replace the magazine.
Action Required