Library Configuration With Cookies - IBM TS2900 Setup, Operator, And Service Manual

number can be changed with the Web User Interface when logged in as service.
Yes
VPD Data
is Saved
Figure 153. Library configuration with cookies
This procedure is used to replace the entire library in the event of a serious library malfunction.
1. If with a static IP address, make a note of your library's IP address. If with DHCP, proceed to the next
step.
2. Remove the old library chassis with the corresponding procedure in "Removing library from a rack"
on page 142 or "Removing library from a desktop" on page 147.
3. Install the new library chassis with the corresponding procedure in "Installing the library on a
desktop" on page 144 or "Installing the library in a rack" on page 149.
4. It is necessary to change the serial number on the new library to the serial number of the old library
to preserve your entitlement to IBM service.
v If you are with a static IP address, complete the following steps.
a. With the Operator Panel, enter the network settings for the library. See "Configuring network
settings" on page 71. Be sure to disable DHCP.
b. Log in to the Web User Interface as admin. The following screen displays.
154
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
Does Auto Saved
VPD Data exist for Library
IP Address?
Yes
Does Library S/N =
Auto Saved S/N?
Write Auto
Saved VPD Data to
Library?
Yes
Auto Saved VPD
Data is written
to Library
Auto Saved
VPD Data is
overwritten
No
VPD Data
is Saved
No
No
Overwrite Auto
Saved VPD Data?
Yes No
Auto Saved
VPD Data is
not overwritten