Attaching The Front Brackets To The Library - IBM TS2900 Setup, Operator, And Service Manual

3. Attach the left 3 and right 4 (Figure 23) front brackets to the front of the library chassis with 2
flat-head screws 8 on each side. Use the bottom two screw holes on each side.
8
Figure 23. Attaching the front brackets to the library chassis
4. Attach the left 1 and right 2 rear brackets to the left 5 and right 6 front rails with 2
round-head screws 10 on each side (Figure 24).
Figure 24. Attaching the rear brackets to the rails
Important: Do NOT tighten these screws completely.
5. Slide in the rear rails 7 from back to front, to create the rail assemblies. Ensure that the screw holes
face outwards (Figure 25 on page 31).
30
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
3
1
5
4
8
12
2
10
6