IBM TS2900 Setup, Operator, And Service Manual page 216

Table 32. Library error codes (continued)
Code (H) Description
Response acknowledge error
received from bar code reader.
0053
Suspect the bar code reader cable
connection.
Receive data checksum error
received from bar code reader.
0056
Suspect the bar code reader cable
connection.
Invalid data received from bar
0057 code reader. Suspect the bar code
reader cable connection.
A bar code reader read-error
0058 detected. Suspect the bar code
reader cable connection.
A bar code reader FLASH control
0059 error detected. Suspect the bar
code reader cable connection.
A bar code reader diagnostics
005A error detected. Suspect the bar
code reader cable connection.
2
I C I/F error. A transfer retry
005B detected. Suspect the bar code
reader cable connection.
2
I C I/F error. Interrupt timeout
005C detected. Suspect the bar code
reader cable connection.
2
I C I/F error.
Invalid signal (NAK) detected.
005D
Suspect the bar code reader cable
connection.
2
I C I/F error.
Bus arbitration lost error detected.
005E
Suspect the bar code reader cable
connection.
2
I C I/F error.
Ready condition does not occur.
005F
Suspect the bar code reader cable
connection.
Calibration failed because the
0070 accessor contains media. Suspect
the centering sensor.
190
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
Panel Indication
1. Initiate an inventory. See "Conducting a
library inventory" on page 66 (Operator
CHK 0053
Panel) or "Conducting a library inventory"
on page 81 (Web User Interface).
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
CHK 0056
Verify before normal library operations
resume.
v If the problem persists, see "Contacting
CHK 0057
IBM technical support" on page 139.
CHK 0058
CHK 0059
CHK 005A
CHK 005B
CHK 005C
CHK 005D
CHK 005E
CHK 005F
1. Attempt to unload the cartridge from the
accessor. See"Moving cartridges" on page 65
(Operator Panel) or "Moving cartridges" on
page 79 (Web User Interface).
2. Cycle the power supply and try again.
CHK 0070
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see "Contacting
IBM technical support" on page 139.
Action Required