Configuring Your Library With The Web User Interface - IBM TS2900 Setup, Operator, And Service Manual

Table 16. Default library configuration settings (continued)
Configuration Item
Primary EKM TCP port number
Primary EKM SSL port number
Secondary EKM server address
Secondary EKM TCP port number
Secondary EKM SSL port number
Advanced encryption settings
NTP server
NTP server address
Time zone (GMT)
Date (MM/DD/YYYY)
Auto adjustment by PC
SMTP (mail) settings
Mail server address
Mail event
SNMP (trap) settings
Community
Trap event
SNMPv3 engine ID
Static library network settings must be entered with the Operator Panel before the library can be accessed
remotely with the Web User Interface. If your system is serviced by a Dynamic Host Configuration
Protocol (DHCP) server, the network parameters are automatically set. Once remote access is established,
you can complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to "Configuring your library with
the Operator Panel" on page 54.

Configuring your library with the Web User Interface

If you choose to use the Web User Interface to configure your library, first enter your library network
settings with the Operator Panel (see "Configuring network settings" on page 71).
To configure your library with the Web User Interface:
1. "Logging in to the Web User Interface" on page 38
2. "Checking firmware level" on page 38
3. "Configuring library settings" on page 39
4. "Configuring network settings" on page 41
5. "Configuring date and time settings" on page 42
6. "Configuring encryption settings" on page 44
7. "Configuring email notifications" on page 47
8. "Configuring trap notifications" on page 48
9. "Managing user access" on page 50
DATE and TIME
NOTIFICATIONS
Default Setting
3801
443
0.0.0.0
3801
443
(None)
Disabled
0.0.0.0
+00:00
01/08/2008
Every 1 minute
0.0.0.0
Error events enabled
Public
Error events enabled
(Set by library firmware)
Installation and configuration
37