IBM TS2900 Setup, Operator, And Service Manual page 238

Table 41. Ultrium Tape drive sense data - Bytes 12 and 13 (continued)
Byte 12 ASC Byte 13 ASCQ
30 03
30 07
30 0C
30 0D
31 00
37 00
3A 00
3B 00
3D 00
3E 00
3F 01
40 xx
43 00
44 00
45 00
4B 00
4E 00
50 00
51 00
52 00
53 00
53 00
53 02
212
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
Description
Cleaning Cartridge Installed - An operation could not be carried out because the
cartridge in the drive is a cleaning cartridge.
Cleaning Failure - A cleaning operation was attempted, but could not be completed
for some reason.
Data Protect - WORM overwrite attempted. The drive rejected a write operation
because it would have resulted in an overwrite. Overwrite is not allowed on
WORM media.
Medium Error - WORM integrity check. The drive rejected a Read or Write
operation because the cartridge is a suspicious WORM cartridge.
Media format corrupted - Data could not be read because the format on tape is not
valid, but is a known format. A failure occurred attempting to write the FID.
Rounded parameter - A Mode Select command parameter has been rounded
because the drive can not store it with the accuracy of the command.
Media Not Present - A media access command has been received when there is no
cartridge loaded.
Sequential Positioning Error - A command has failed and left the logical position at
an unexpected location.
Invalid bits in identify Message - An illegal Identify Message has been received at
the drive at the start of a command.
Logical Unit has not Self-Configured - The drive has just powered on and has not
completed its self test sequence and can not process commands.
Code Download - The firmware in the drive has just been changed by a Write
Buffer command.
Diagnostic failure - A diagnostic test has failed. The xx (ASCQ) is a vendor specific
code indicating the failing component.
Message Error - A message could not be sent or received due to excessive
transmission errors.
Internal target failure - A hardware failure has been detected in the drive that has
caused the command to fail.
Select/Reset Failure - An attempt to reselect an initiator in order to complete the
command has failed.
Data Phase Error - A command could not be completed because too many parity
errors occurred during the Data phase.
Overlapped Commands - An initiator selected the drive even though it already
had a command outstanding in the drive.
Write Append Error - A write type command failed because the point at which to
append data was unreadable.
Erase failure - An Erase command failed to erase the required area on the media.
Cartridge fault - A command could not be completed due to a fault in the tape
cartridge.
Media Load/Eject Failed - (Sense Key 03) An attempt to load or eject the cartridge
failed due to a problem with the cartridge.
Media Load/Eject Failed - (Sense Key 04) An attempt to load or eject the cartridge
failed due to a problem with the drive.
Media Removal Prevented - An Unload command has failed to eject the cartridge
because media removal has been prevented.