Installing An Internal Dat Tape Drive; Prepare Mounting Bay - HP StorageWorks DAT 72 User Manual

Dat tape drives
Hide thumbs Also See for StorageWorks DAT 72:
Table of Contents

Advertisement

3

Installing an internal DAT tape drive

If you are installing an external DAT tape drive, please refer to
NOTE:
It is important to ensure that you connect your drive to a USB 2.0 port. The drive will work
on a USB 1.1 port but performance will be severely degraded. See also
for optimum
performance" on page 42.

Prepare mounting bay

CAUTION:
To avoid personal injury or damage to the server or tape drive, ensure that the server is
disconnected from the mains power supply while you install the drive.
1.
Assemble the necessary tools and materials:
• Phillips screwdriver
• Flat-bladed screwdriver (if your server uses slotted screws)
• Torx screwdriver (if your server uses torx screws)
• Your server manuals (for reference during installation)
2.
Perform a normal system shutdown and turn off the server and any connected peripherals.
3.
Remove the cover and front panel from the server, as detailed in your server's documentation.
As you work inside the server, you may have to disconnect other signal cables or power cables
from other devices to maneuver the new drive into place. If you have to do this, make a note of
their position and connections so you can put them back correctly later.
Chapter
4.
HP StorageWorks DAT Tape Drives User Guide
"Verifying USB installation
11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the StorageWorks DAT 72 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Storageworks dat 40Storageworks dat 24

Table of Contents

Save PDF