ZyXEL Communications NXC2500 User Manual page 384

Appendix A Log Descriptions
Table 189 CAPWAP Client Logs
LOG MESSAGE
Updated Configuration by a WLAN
Controller Success. Partial
Update
Updated Configuration by a WLAN
Controller Fail.
ReBoot by a WLAN Controller.
IP:%s
Firmware Upgraded by WLAN
Controller. IP:%s
Apply Configuration by a WLAN
Controller Success.%s
WLAN Controller IP Changed. New
Discovery Type:%s, WLAN
Controller IP: %s
AP Receiving Complete ZySH
Configuration from WLAN
Controller.
AP Receiving Updating ZySH
Configuration from WLAN
Controller.
STA List Full. STA List of AP [%s]
is Full
DNS Query result is NULL.
Table 190 AP Load Balancing Logs
LOG MESSAGE
kick station
%02x:%02x:%02x:%02x:%0
2x:%02x
Table 191 Rogue AP Logs
LOG MESSAGE
rogue ap detection is
enabled.
384
DESCRIPTION
Configuration upgraded success by WLAN Controller.
Configuration upgraded fail by WLAN Controller.
Reboot the WTP by WLAN Controller.
1st %s: WLAN Controller IP Address.
Firmware upgraded by WLAN Controller.
1st %s: WLAN Controller IP Address.
Configuration apply success by WLAN Controller.
1st %s: Complete Update
Changed WTP's AC IP.
1st %s: Discovery type {Static | DHCP | DNS | Broadcast}
2nd %s: WLAN Controller IP Address
WTP receiving total configuration from WLAN Controller during
CAPWAP protocol handshaking. (Configuration Change State)
WTP receiving total configuration from WLAN Controller When
AC changed configuration. (RUN State)
Number of stations connecting to the specified AP has reached
its upper limit.
1st %s: WTP's description.
A DNS query failed.
DESCRIPTION
Indicates that the specified station was removed from an AP's wireless
network because the AP became overloaded.
DESCRIPTION
Indicates that rogue AP detection is enabled.
NXC2500 User's Guide