Table of Contents
Advertisement
Appendix A Log Descriptions
Table 174 Policy Route Logs (continued)
LOG MESSAGE
Policy-route rule %d
was deleted.
Policy-route rules
were flushed.
BWM has been
activated.
BWM has been
deactivated.
Table 175 Built-in Services Logs
LOG MESSAGE
User on %u.%u.%u.%u
has been denied access
from %s
HTTPS certificate:%s
does not exist. HTTPS
service will not work.
HTTPS port has been
changed to port %s.
HTTPS port has been
changed to default
port.
HTTP port has changed
to port %s.
HTTP port has changed
to default port.
SSH port has been
changed to port %s.
SSH port has been
changed to default
port.
SSH certificate:%s
does not exist. SSH
service will not work.
SSH certificate:%s
format is wrong. SSH
service will not work.
TELNET port has been
changed to port %s.
TELNET port has been
changed to default
port.
368
DESCRIPTION
Rule is deleted.
%d: the policy route rule number
Policy routing rules are cleared.
The global setting for bandwidth management on the NXC has been turned on.
The global setting for bandwidth management on the NXC has been turned off.
DESCRIPTION
HTTP/HTTPS/TELNET/SSH/FTP/SNMP access to the device was denied.
%u.%u.%u.%u is IP address
%s is HTTP/HTTPS/SSH/SNMP/FTP/TELNET
An administrator assigned a nonexistent certificate to HTTPS.
%s is certificate name assigned by user
An administrator changed the port number for HTTPS.
%s is port number
An administrator changed the port number for HTTPS back to the default
(443).
An administrator changed the port number for HTTP.
%s is port number assigned by user
An administrator changed the port number for HTTP back to the default (80).
An administrator changed the port number for SSH.
%s is port number assigned by user
An administrator changed the port number for SSH back to the default (22).
An administrator assigned a nonexistent certificate to SSH.
%s is certificate name assigned by user
After an administrator assigns a certificate for SSH, the device needs to
convert it to a key used for SSH.
%s is certificate name assigned by user
An administrator changed the port number for TELNET.
%s is port number assigned by user
An administrator changed the port number for TELNET back to the default
(23).
NXC2500 User's Guide
Advertisement
Table of Contents
Troubleshooting
