Table of Contents
Advertisement
Chapter 26 File Manager
These files have the same syntax, which is also identical to the way you run CLI commands
manually. An example is shown below.
Figure 179 Configuration File / Shell Script: Example
# enter configuration mode
configure terminal
# change administrator password
username admin password 4321 user-type admin
# configure ge3
interface ge3
ip address 172.16.37.240 255.255.255.0
ip gateway 172.16.37.254 metric 1
exit
# create address objects for remote management
# use the address group in case we want to open up remote management later
address-object TW_SUBNET 172.16.37.0/24
object-group address TW_TEAM
address-object TW_SUBNET
exit
# enable Telnet access (not enabled by default, unlike other services)
ip telnet server
# open WLAN-to-NXC firewall for TW_TEAM for remote management
firewall WLAN NXC insert 4
sourceip TW_TEAM
service TELNET
action allow
exit
write
While configuration files and shell scripts have the same syntax, the NXC applies configuration files
differently than it runs shell scripts. This is explained below.
Table 155 Configuration Files and Shell Scripts in the NXC
Configuration Files (.conf)
•
Resets to default configuration.
•
Goes into CLI Configuration mode.
•
Runs the commands in the configuration file.
You have to run the aforementioned example as a shell script because the first command is run in
Privilege mode. If you remove the first command, you have to run the example as a configuration
file because the rest of the commands are executed in Configuration mode.
Comments in Configuration Files or Shell Scripts
In a configuration file or shell script, use "#" or "!" as the first character of a command line to have
the NXC treat the line as a comment.
Your configuration files or shell scripts can use "exit" or a command line consisting of a single "!" to
have the NXC exit sub command mode.
Note: "exit" or "!'" must follow sub commands if it is to make the NXC exit sub command
mode.
314
Shell Scripts (.zysh)
•
Goes into CLI Privilege mode.
•
Runs the commands in the shell script.
NXC2500 User's Guide
Advertisement
Table of Contents
Troubleshooting
