Table of Contents
Advertisement
Server tab. The screen appears as shown. Use this screen to enable the authentication server
feature of the NXC and specify the RADIUS client's IP address.
Figure 170 Configuration > System > Auth. Server
The following table describes the labels in this screen.
Table 146 Configuration > System > Auth. Server
LABEL
Enable
Authentication
Server
Certificate
Authentication
Method
Service Control
Add
Edit
Remove
Activate
Inactivate
#
Status
Profile Name
IP Address
Mask
Description
Apply
Reset
NXC2500 User's Guide
DESCRIPTION
Select the check box to have the NXC act as a RADIUS server.
Select the certificate whose corresponding private key is to be used to identify the NXC to
the RADIUS client. You must have certificates already configured in the My Certificates
screen.
Select an authentication method if you have created any in the Configuration > Object >
Auth. Method screen.
This specifies from which computers you can access which NXC zones.
Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The NXC confirms you want to remove it
before doing so. Note that subsequent entries move up by one when you take this action.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This is the index number of the entry.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field indicates the name assigned to the profile.
This is the IP address of the RADIUS client that is allowed to exchange messages with the
NXC.
This is the subnet mask of the RADIUS client.
This is the description of the RADIUS client.
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
Chapter 24 System
293
Advertisement
Table of Contents
Troubleshooting
