Table of Contents
Advertisement
Chapter 8 Interfaces
Table 56 Configuration > Network > Interface > VLAN > Add/Edit (continued)
LABEL
Interface Properties
Interface Name
VID
Zone
Description
Member
Configuration
Edit
#
Port Name
Member
Tx Tagging
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
Metric
Related Setting
Configure Policy
Route
Interface
Parameters
Egress
Bandwidth
118
DESCRIPTION
This field is read-only if you are editing an existing VLAN interface. Enter the number of
the VLAN interface. You can use a number from 0~4094. For example, vlan0, vlan8,
and so on.
Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN. Allowed values
are 1 - 4094. (0 and 4095 are reserved.)
Select the zone to which the VLAN interface belongs.
Enter a description of this interface. It is not used elsewhere. You can use alphanumeric
and
()+/:=?!*#@$_%-
Use these settings to assign interfaces to this VLAN as members.
Click this to edit the selected interface's membership values.
This is sequential indicator of the interface number.
This indicates the interface name.
This indicates whether the selected interface is a member or not of the VLAN which is
currently being edited.
Click this field to edit the value.
This indicates whether the selected interface tags outbound traffic with this VLAN's ID .
Click this field to edit the value.
Select this if this interface is a DHCP client. In this case, the DHCP server configures the
IP address, subnet mask, and gateway automatically.
Select this if you want to specify the IP address, subnet mask, and gateway manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The NXC sends packets to the gateway when it
does not know how to route the packet to its destination. The gateway should be on the
same network as the interface.
Enter the priority of the gateway (if any) on this interface. The NXC decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the NXC uses the one that was
configured first.
Click Policy Route to go to the screen where you can manually configure a policy route
to associate traffic with this VLAN.
Enter the maximum amount of traffic, in kilobits per second, the NXC can send through
the interface to the network. Allowed values are 0 - 1048576.
characters, and it can be up to 60 characters long.
NXC2500 User's Guide
Advertisement
Table of Contents
Troubleshooting
