ZyXEL Communications NXC2500 User Manual page 110

Chapter 8 Interfaces
Table 51 Configuration > Network > Interface > Ethernet > Edit (continued)
LABEL
Edit
Remove
#
Name
Code
Type
Value
Enable IP/MAC
Binding
Enable Logs for
IP/MAC Binding
Violation
Static DHCP
Table
Add
Edit
Remove
#
IP Address
MAC
Description
MAC Address
Setting
Use Default MAC
Address
Overwrite
Default MAC
Address
Related Setting
Configure Policy
Route
OK
Cancel
110
DESCRIPTION
Select an entry in this table and click this to modify it.
Select an entry in this table and click this to delete it.
This field is a sequential value, and it is not associated with any entry.
This is the name of the DHCP option.
This is the code number of the DHCP option.
This is the type of the set value for the DHCP option.
This is the value set for the DHCP option.
Select this option to have this interface enforce links between specific IP addresses and
specific MAC addresses. This stops anyone else from manually using a bound IP address
on another device connected to this interface. Use this to make use only the intended
users get to use specific IP addresses.
Select this option to have the NXC generate a log if a device connected to this interface
attempts to use an IP address that is bound to another device's MAC address.
Configure a list of static IP addresses the NXC assigns to computers connected to the
interface. Otherwise, the NXC assigns an IP address dynamically using the interface's
IP Pool Start Address and Pool Size.
Click this to create a new entry.
Select an entry and click this to be able to modify it.
Select an entry and click this to delete it.
This field is a sequential value, and it is not associated with a specific entry.
Enter the IP address to assign to a device with this entry's MAC address.
Enter the MAC address to which to assign this entry's IP address.
Enter a description to help identify this static DHCP entry. You can use alphanumeric
and ()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
Have the interface use either the factory assigned default MAC address, a manually
specified MAC address, or clone the MAC address of another device or computer.
Select this option to have the interface use the factory assigned default MAC address.
By default, the NXC uses the factory assigned MAC address to identify itself.
Select this option to have the interface use a different MAC address. Either enter the
MAC address in the fields or click Clone by host and enter the IP address of the device
or computer whose MAC you are cloning. Once it is successfully configured, the address
will be copied to the configuration file. It will not change unless you change the setting
or upload a different configuration file.
Click Policy Route to go to the policy route summary screen where you can manually
associate traffic with this interface.
You must manually configure a policy route to add routing and SNAT settings for an
interface with the Interface Type set to General. You can also configure a policy route
to override the default routing and SNAT behavior for an interface with the Interface
Type set to Internal or External.
Click OK to save your changes back to the NXC.
Click Cancel to exit this screen without saving.
NXC2500 User's Guide