Example Interface And Zone Configuration - ZyXEL Communications NXC2500 User Manual

Chapter 1 Introduction
• VLAN interfaces recognize tagged frames. The NXC automatically adds or removes the tags as
needed. Each VLAN can only be associated with one Ethernet interface.
Note: By default, all Ethernet interfaces are placed into vlan0, allowing the NXC to
function as a bridge device.

1.2.2 Example Interface and Zone Configuration

This section introduces the NXC's default zone member physical interfaces and the default
configuration of those interfaces. The following figure uses letters to denote public IP addresses or
part of a private IP address.
Figure 1 Default Network Topology
Table 2 NXC Sample Topology
PORT
P1~P6
CONSOLE
• The LAN zone contains the ge1~ ge6 interfaces (physical ports P1~P6). By default, all LAN
interfaces are put in vlan0.
• The console port is not in a zone and can be directly accessed by a computer attached to it using
a special console-to-Ethernet adapter.
18
INTERFACE ZONE
ge1~ge6 LAN
(vlan0)
N/A None
IP ADDRESS AND DHCP
SETTINGS
192.168.1.1, DHCP server
enabled
None
SUGGESTED USE WITH DEFAULT
SETTINGS
Dedicated LAN connections
Local management
NXC2500 User's Guide