Host Name; Usb Storage - ZyXEL Communications NXC2500 User Manual

Chapter 24 System

24.2 Host Name

A host name is the unique name by which a device is known on a network. Click Configuration >
System > Host Name to open this screen.
Figure 143 Configuration > System > Host Name
The following table describes the labels in this screen.
Table 129 Configuration > System > Host Name
LABEL
System Name
Domain Name
Apply
Reset

24.3 USB Storage

The NXC can use a connected USB device to store the system log and other diagnostic information.
Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > System > USB Storage to open the screen as shown next.
Figure 144 Configuration > System > USB Storage
260
DESCRIPTION
Choose a descriptive name to identify your NXC device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes "-" are accepted.
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
NXC2500 User's Guide