Table of Contents
Advertisement
Chapter 24 System
Table 142 Configuration > System > TELNET (continued)
LABEL
Apply
Reset
24.10 FTP
You can upload and download the NXC's firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See
about firmware and configuration files.
To change your NXC's FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the NXC. You can
also specify from which IP addresses the access can come.
Figure 167 Configuration > System > FTP
The following table describes the labels in this screen.
Table 143 Configuration > System > FTP
LABEL
Enable
TLS required
Server Port
Server
Certificate
Service Control
288
DESCRIPTION
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the NXC using this service.
Select the check box to use FTP over TLS (Transport Layer Security) to encrypt
communication.
This implements TLS as a security mechanism to secure FTP clients and/or servers.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Select the certificate whose corresponding private key is to be used to identify the NXC for
FTP connections. You must have certificates already configured in the My Certificates
screen.
This specifies from which computers you can access which NXC zones.
Chapter 26 on page 313
for more information
NXC2500 User's Guide
Advertisement
Table of Contents
Troubleshooting
