Table 138: Multicast Vlan Registration For Ipv4 Commands; Mvr For Ipv4 - Edge-Core ECS4120-28F Reference Manual

Chapter 24
| Multicast Filtering Commands

MVR for IPv4

MVR for IPv4
This section describes commands used to configure Multicast VLAN Registration for
IPv4 (MVR). A single network-wide VLAN can be used to transmit multicast traffic
(such as television channels) across a service provider's network. Any multicast
traffic entering an MVR VLAN is sent to all subscribers. This can significantly reduce
to processing overhead required to dynamically monitor and establish the
distribution tree for a normal multicast VLAN. Also note that MVR maintains the
user isolation and data security provided by VLAN segregation by passing only
multicast traffic into other VLANs to which the subscribers belong.

Table 138: Multicast VLAN Registration for IPv4 Commands

Command
mvr
mvr associated-profile
mvr domain
mvr priority
mvr profile
mvr proxy-query-interval
mvr proxy-switching
mvr robustness-value
mvr source-port-mode
dynamic
mvr upstream-source-ip
mvr vlan
mvr immediate-leave
mvr type
mvr vlan group
clear mvr groups dynamic
clear mvr statistics
show mvr
Function
Globally enables MVR
Binds the MVR group addresses specified in a profile to an
MVR domain
Enables MVR for a specific domain
Assigns a priority to all multicast traffic in the MVR
VLAN
Maps a range of MVR group addresses to a profile
Configures the interval at which the receiver port sends out
general queries.
Enables MVR proxy switching, where the source port acts
as a host, and the receiver port acts as an MVR router with
querier service enabled
Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
Configures the switch to only forward multicast streams
which the source port has dynamically joined
Configures the source IP address assigned to all control
packets sent upstream
Specifies the VLAN through which MVR multicast data is
received
Enables immediate leave capability
Configures an interface as an MVR receiver or source port
Statically binds a multicast group to a port
Clears multicast group information dynamically learned
through MVR
Clears MVR statistics
Shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current
number of group addresses, and the upstream source IP
address
– 698 –
Mode
GC
GC
GC
GC
GC
GC
GC
GC
GC
GC
GC
IC
IC
IC
PE
PE
PE