Solutions Module Identification Code; Solutions Module Software Version - Emerson 2202 Advanced User's Manual

Parameter Parameter
Introduction
x.00 description format
SM-I/O Lite & SM-I/O Timer
The Commander SK SM-I/O Lite & SM-I/O Timer options have an analog input that operates with a 11 bit resolution in both voltage and current
modes.
The analog output has a resolution of approximately 13 bits (± 1.25mV resolution in voltage mode and ± 2.5μA resolution in current mode).
Input / outputs - sample times / update rates
The communications between the drive and the Solutions Module is through a synchronous serial link operating at 100kHz. The update rate of the
I/O is dependant on the number of I/O being used.
If fast update rates of I/O are required, the drive I/O should be used or the Solutions Module I/O loading should be kept to a minimum.
I/O description
Background (mandatory)
Digital input 1
Digital input 2
Digital input 3/ Encoder input
Relay output
Analog input (10/11 bit)
Analog output
Total update time for all
Sample calculation of update rate:
Analog input (2) + analog output (3)+ digital input (2) + relay output (2) + background (5) = 14 ms
* When the analog input is routed to precision reference parameters, Pr 1.18 and Pr 1.19, the worst-case update time is 4 x 2 = 8 ms
NOTE
If a 32 bit parameter is used as a source parameter on a Solutions Module, then it should be routed via a Menu 18 parameter e.g. Pr 18.12.
NOTE
The encoder reference input is only active when the destination parameter (Pr 15.59) is routed to a valid parameter.
15.01

Solutions module identification code

Bit SP
Coding
Range 0 or 599
Default See Table 10-26 Solutions Module ID on page 171
Update rate Write on power up
The new parameter values are stored automatically by the drive. If the drive is subsequently powered up with a different Solutions Module installed or
no Solutions Module installed when one was previously installed. The drive will trip on SL.dF or SL.nF.
15.02

Solutions Module software version

Bit SP
Coding
Range 00.00 to 99.99
Update rate Write on power up
This parameter shows the version of software programmed into the Solutions Module. The software sub version is displayed in Pr 15.51.
These two parameters display the software version in the form of:
Pr 15.02 = xx.yy
Pr 15.51 = zz
15.03 Current loop loss indicator
Bit SP
Coding
1
Range OFF(0) or On(1)
Update rate Background write
If the SM-I/O Lite/ SM-I/O Timer analog input is programmed in any of the modes 2 to 5 (see Pr 15.38) then this bit is set if the current input falls below
3mA. This bit can be designated to a digital output to indicate that the current input is less than 3mA.
Commander SK Advanced User Guide
Issue Number: 9
Keypad and Serial
display communications
Required update time (ms)
5
2
2
2
2
2/8*
3
18/24*
FI DE Txt VM DP ND
1
FI DE Txt VM DP ND
2 1
FI DE Txt VM DP ND
1
CT Modbus PLC Ladder
RTU programming
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Advanced parameter
CTSoft Menu 0
descriptions
PS
1
PS
1
PS
Menu 15
I/O options
177