Real Time Clock Daylight Saving Mode; Terminal T5-7 Digital Input 1-3 Destination; Terminal T21/T23 Relay 1 Source - Emerson 2202 Advanced User's Manual

Parameter Parameter
Introduction
x.00 description format
15.19

Real time clock daylight saving mode

Bit SP
Coding
1
Range OFF(0) or On(1)
Default OFF(0)
Update rate Background read
0: OFF Real time clock normal operation
1: On Real time clock + 1 hour
NOTE
The real time clock is not available on SM-I/O Lite.
15.20 Digital I/O read word
Bit SP
Coding
Range 0 to 120
Update rate Background write
This word is used to determine the status of the digital I/O by reading one parameter.
Pr 15.20 contains a binary value 'xx'. This binary value is determined by the state of Pr 15.04 to Pr 15.07. So for example, if all terminals were active
the value displayed in Pr 15.20 would be the sum of the binary values shown in the table, i.e. 120.
Binary value for xx
1
2
4
8
16
32
64
128
15.21 to 15.23 Unused parameters
15.24 Terminal T5 digital input 1 destination
15.25 Terminal T6 digital input 2 destination
15.26 Terminal T7 digital input 3 destination
Bit SP
Coding
Range Pr 0.00 to Pr 21.51
Default Pr 0.00
Update rate Read on drive reset
Destination parameters define the parameter each of the programmable inputs is to control. Only parameters that are not protected can be controlled
by the programmable digital inputs. If a non-valid parameter is programmed, the digital input is not routed anywhere.
15.27

Terminal T21/T23 relay 1 source

Bit SP
Coding
Range Pr 0.00 to Pr 21.51
Default Pr 0.00
Update rate Read on drive reset
This parameter defines the parameter to be represented by the status relay. Only valid parameters can be selected as a source for the relay output. If
a non-valid parameter is programmed, then the relay will remain in the last known state.
15.28 to 15.29 Unused parameter
Commander SK Advanced User Guide
Issue Number: 9
Keypad and Serial
display communications
FI DE Txt VM DP ND
FI DE Txt VM DP ND
1
Digital I/O
Terminal T5
Terminal T6
Terminal T7
Terminals T21 & T23
FI DE Txt VM DP ND
1 2
FI DE Txt VM DP ND
1 2
CT Modbus PLC Ladder
RTU programming
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1 1
RA NC NV PT US RW BU
1 1 1
Advanced parameter
CTSoft Menu 0
descriptions
PS
PS
1
PS
1
PS
1
Menu 15
I/O options
179