Load Defaults; Security Status - Emerson 2202 Advanced User's Manual

Parameter Parameter
Introduction
x.00 description format
Parameter number
2.08 Standard ramp voltage
4.07, 21.29 Current limits
5.07, 21.07 Motor rated currents
5.09, 21.09 Motor rated voltages
5.10, 21.10 Motor rated power factor
5.17, 21.12 Stator resistances
5.18 Switching frequency
5.23, 21.13 Voltage offsets
5.24, 21.14 Transient inductances
6.06 DC injection braking current
NOTE
If parameter copying is enabled when no SmartStick is installed into the drive, the drive's display will show a C.Acc trip.
NOTE
The SmartStick should be fully inserted or removed from the drive before a drive reset is performed.
11.43

Load defaults {29}

Bit SP
Coding
Range no(0), Eur(1), USA(2)
Default no(0)
Update rate Actioned on exit of edit mode or drive reset
If this parameter is set to a non-zero value and edit mode is exited or the drive is reset when the drive is inactive, the selected default parameters will
automatically be loaded. After the parameters have been set to default values they are automatically saved to the drive's internal EEPROM. If the
drive is active the display will flash FAIL once and then Pr 11.43 will be set back to no.
Value Display
0 no No action
1 Eur Load European defaults
2 USA Load USA defaults
Disconnect the electro-mechanical brake circuit before performing a default.
WARNING
11.44

Security status {10}

Bit SP
Coding
Range L1(0), L2(1), L3(2), LoC(3)
Default L1(0)
Update rate Actioned on exit of edit mode
This read write parameter defines the level of security for menu 0.
Value Level
0 L1 Only the first ten parameters can be accessed.
1 L2 Parameters up to 60 can be accessed.
2 L3 Parameters up to 95 can be accessed.
Lock security, so that the security code must be entered before a parameter can
3 LoC
be edited and set security status to L1.
The LED keypad can adjust this parameter even when user security is set.
Commander SK Advanced User Guide
Issue Number: 9
Keypad and Serial
display communications
Function
FI DE Txt VM DP ND
1
Function
FI DE Txt VM DP ND
1 1
Access permitted
www.controltechniques.com
CT Modbus PLC Ladder
RTU programming
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Advanced parameter
CTSoft Menu 0
descriptions
PS
1
PS
1
Menu 11
149