Motor 2 Maximum Set Speed; Motor 2 Minimum Set Speed; Motor 2 Reference Selector - Emerson 2202 Advanced User's Manual

Parameter Parameter
Introduction
x.00 description format
21.01

Motor 2 maximum set speed

Bit SP
Coding
Range 0.0 to 550 Hz
Eur: 50.0
Default
USA: 60.0
First motor
Pr 1.06
parameter
Update rate Background
This parameter is a symmetrical limit on both directions of rotation.
Defines drive absolute maximum frequency reference. Slip compensation and current limit can increase the motor frequency further.
21.02

Motor 2 minimum set speed

Bit SP
Coding
Range 0.0 to 550 Hz
Default 0.0
First motor
Pr 1.07
parameter
Update rate Background
Used in unipolar mode to define drive minimum set speed. This can be overridden if the maximum set speed clamp Pr 21.01 is adjusted to be less
than Pr 21.02. Inactive during jogging.
21.03

Motor 2 reference selector

Bit SP
Coding
Range A1.A2(0), A1.Pr(1), A2.Pr(2), Pr(3), PAd(4), Prc(5)
Default A1.A2(0)
First motor
Pr 1.14
parameter
Update rate 5ms
NOTE
When motor 2 selected (Pr 11.45 = On), the speed reference must be set correctly using Pr 21.03.
0: A1.A2 Analog reference 1 or 2 selected by terminal input
1: A1.Pr Analog reference 1 (current) or 3 Presets selected by terminal input
2: A2.Pr Analog reference 1 (voltage) or 3 Presets selected by terminal input
3: Pr 4 Preset speeds selected by terminal input
4: PAd Keypad reference selected
5: Prc Precision reference selected
With Eur defaults
Terminal B4
Pr 21.03
destination
A1.A2(0) Pr 6.29
A1.Pr(1) Pr 1.45
A2.Pr(2) Pr 1.45
Pr(3) Pr 1.45
PAd(4)
Prc(5)
Commander SK Advanced User Guide
Issue Number: 9
Keypad and Serial
display communications
FI DE Txt VM DP ND
1
FI DE Txt VM DP ND
1 1
FI DE Txt VM DP ND
1
Terminal B7
destination
Pr 1.41 Selected by terminal input
Pr 1.46
Pr 1.46
Pr 1.46
www.controltechniques.com
CT Modbus PLC Ladder
RTU programming
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Pr 1.49
1
2
3
4
5
Advanced parameter
CTSoft Menu 0
descriptions
PS
1
PS
1
PS
1
Menu 21
189