Menu 7: Analog Inputs And Outputs - Emerson 2202 Advanced User's Manual

Parameter Parameter
Introduction
x.00 description format
10.8

Menu 7: Analog inputs and outputs

Table 10-9 Menu 7 parameters: single line descriptions
Parameter
7.01 Analog input 1 level (terminal T2)
7.02 Analog input 2 level (terminal T4)
7.03 Not used
7.04 Heatsink temperature
7.05 Power circuit temperature 2
7.06 Analog input 1 mode (terminal T2)
7.07 Not used
7.08 Analog input 1 scaling
7.09 Analog input 1 invert
7.10 Analog input 1 destination
7.11 Analog input 2 mode (terminal T4)
7.12 Analog input 2 scaling
7.13 Analog input 2 invert
7.14 Analog input 2 destination
7.15 Not used
7.16 Not used
7.17 Not used
7.18 Not used
7.19 Analog output source
7.20 Analog output scaling
7.21 Not used
7.22 Not used
7.23 Not used
7.24 Not used
7.25 Not used
7.26 Not used
7.27 Not used
7.28 Current loop loss indicator
7.29 Not used
7.30 Analog input 1 offset
7.31 Analog input 2 offset
7.32 Not used
7.33 Analog output control (Terminal B1)
7.34 IGBT junction temperature
7.35 Drive thermal protection accumulator
7.36 Power circuit temperature 3
Commander SK Advanced User Guide
Issue Number: 9
Keypad and Serial CT Modbus
display communications RTU
{94)
{95}
0 -20(0), 20-0(1), 4-20(2),
{16} 20-4(3), 4-.20(4), 20-.4(5),
Fr(0), Ld(1), A(2), Por(3),
{36}
www.controltechniques.com
PLC Ladder
CTSoft
programming
Range Default
0.0 to 100.0%
0.0 to 100.0%
-128 to 127 °C
-128 to 127 °C
4-.20(4)
VoLt(6)
0.000 to 4.000 1.000
OFF(0) or On(1) OFF(0)
Pr 0.00 to Pr 21.51 Pr 1.36
VoLt(0) or dig(1) VoLt(0)
0.000 to 4.000 1.000
OFF(0) or On(1) OFF(0)
Pr 0.00 to Pr 21.51 Pr 1.37
Pr 0.00 to Pr 21.51 Pr 2.01
0.000 to 4.000 1.000
OFF(0) or On(1)
±100.0%
±100.0%
Fr(0)
USEr(4)
±200 °C
0 to 100%
-128 to 127 °C
Advanced parameter
Menu 0
descriptions
Setting Update Rate
Drive reset
Drive reset
Drive reset
0.0
0.0
Edit mode exit
Menu 7
5 ms
5 ms
B
B
B
B
5 ms
B
B
5 ms
21 ms
5 ms
5 ms
5 ms
B
B
B
101